Grounding The Mx204 Router - Juniper MX204 Hardware Manual

MX204 3D Universal Edge Router Hardware Guide
Related
Documentation

Grounding the MX204 Router

72
Grounding the MX204 Router on page 72
MX204 Router Grounding Specifications on page 30
General Safety Guidelines and Warnings on page 133
General Electrical Safety Guidelines and Warnings on page 155
Prevention of Electrostatic Discharge Damage on page 156
You ground the router by connecting a grounding cable to earth ground and then attaching
it to the chassis grounding points by using two 10–32 screws.
the grounding point location on the chassis. You must provide the grounding cables (the
cable lugs are supplied with the router). For grounding cable specifications, see
Router Grounding Specifications" on page
Figure 33: Grounding Point on the MX204 Router
1
Rear panel
1— Grounding point
To ground the router:
Verify that a licensed electrician has attached the cable lug provided with the router
1.
to the grounding cable.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to an approved site ESD grounding point. See the instructions for your site.
Ensure that all grounding surfaces are clean and brought to a bright finish before
3.
grounding connections are made.
Connect the grounding cable to a proper earth ground.
4.
Detach the ESD grounding strap from the site ESD grounding point.
5.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
6.
ESD points on the chassis.
Place the grounding cable lug over the grounding point on the chassis.
7.
Figure 33 on page 72
30.
Copyright © 2018, Juniper Networks, Inc.
shows
"MX204