Install Cylinder; Install Inside Trim - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

ML2000 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators
Installation Instructions
5 Installation Instructions (cont .)
d

Install Cylinder

1. Thread cylinder into lock until flush with surface.
2. Install the cylinder clamp screw (#2 Phillips screwdriver).
3. Check operation, and adjust cylinder if necessary.
4. Secure lock in door with two (2) Combination screws
Do NOT tighten completely at this time. (Figure 12)
NOTE:
• CORBIN RUSSWIN logo must be horizontal and on top
portion of cylinder.
• Designed for 1-1/8" cylinders. For longer cylinders consult
factory.
e

Install Inside Trim

1. Install inside escutcheon assembly Using two (2) through-bolt screws. (Figure 13)
NOTE:
Engage both spindle and spindle cam with lock body.
2. Verify indicator is in unlocked position.
Note:
• Screw heads should be visible on inside
escutcheon.
• If a turn-piece is required, it should be oriented
vertically.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Inside of door
Cylinder Clamp
Screw
Lock Screw
Figure 12
Escutcheon
Assembly
#8-32 x 2-1/4"
Screws
Spindle Cam
Spindle
Figure 13
7
Outside of door
Cylinder
RH door
shown
FM521 08/19