Standard Levers Only: Attach Levers - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

ML2000 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators
Installation Instructions
5 Installation Instructions (cont .)
f

STANDARD LEVERS ONLY: Attach Levers

1. Install outside lever or knob by inserting
adjustment bolt on opposite side of door.
Tighten bolt finger-tight and loosen a few turns.
2. Install inside lever or knob by inserting dowel
screw. (Figure 14)
NOTE:
Use correct spindle orientation.
(Figure 15)
NOTE:
Make sure adjustment bolt hole is aligned with lever or knob hole. (Figure 16)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
BAD GOOD
Lever
Figure 15
Adjustment Bolt
Misaligned.
Adjustment bolt
needs to be threaded
in farther.
Dowel
Screw
Inside
Lever
Adjustment
Bolt
Inside
Spindle
Bushing
Adjustment Bolt
Misaligned.
Adjustment bolt needs
to be unthreaded.
Figure 16
Bushing
Figure 14
Adjustment Bolt
Adjustment bolt fully
aligned with lever
hole and ready to be
secured with set screw.
8
Outside Level
plus Spindle
FM521 08/19