Install Cylinder; Install Outside Front - Assa Abloy Corbin Russwin MP6600 Series Installation Instructions Manual

MP6600 Series Multi-Point Lock
Used with VN1 Escutcheon Trim and V Series Indicators
Installation Instructions
5 Installation, continued
e

Install Cylinder

1. Thread cylinder into lock until flush with
escutcheon surface. (Figure 9)
• Pull key slightly out of cylinder to help thread
into lock body.
2. Tighten cylinder clamp screw with #1 Phillips
screwdriver.
• Check operation and adjust cylinder if
necessary.
Notes:
• SARGENT logo must be horizontal and on
top. (Figure 10)
• If double cylinder function is used, repeat
steps 1 and 2 for second cylinder.
• Removable Core or Interchangeable Core
cylinders require a control key (key stamped
with C) to remove and install the core. This is
not provided standard; it must be requested
separately. If requesting 1-bitted control key,
specify 113511 cut.
f

Install Outside Front

1. Tighten the two (2) lock screws completely. (Figure 11)
2. Attach outside front with two (2) flat head screws #8-32 x 1/4.
g Perform Function Check
DO NOT FORCE if resistance is encountered during functional
check. Refer back to Rehanding Indicator (if required) section
to ensure correct handing. Rehand if necessary.
1. Insert key into cylinder (if present) and rotate:
• Ensure there is no friction against lock case or
any other obstructions.
2. Check key retracts latch:
• Key should rotate freely.
3. Throw deadbolt (if present):
• Check key retracts both deadbolt and latch.
4. Test levers:
• Confirm latch and deadbolt (if installed) retract.
5. Verify indicator displays correct status when locked
and unlocked
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Cylinder
Clamp
Screw
Key and cylinder must be rotated as shown.
Figure 10
Correct
Lock
screw
Outside
front
#8-32 x
1/4" screws
Figure 11
6
Figure 9
Cylinder
Incorrect
Lock screw
FM556 08/20