Rehanding Indicator (If Necessary) - Assa Abloy Corbin Russwin ML2000 Series Installation Instructions Manual

ML2000 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators
Installation Instructions
4

Rehanding Indicator (if necessary)

1. Verify hand and bevel of door. (Figure 7)
Left Hand
Hinges Left
Open Inward
Note:
Stand on outside of locked door when determining door hand.
2. Remove indicator back plate by pulling out from top slot.
3. Remove spindle cam from assembly.
4. Position the spindle cam in the correct direction for door hand. (Figure 8)
5. Slide spindle cam post into the correct slot of the display slide (Figure 9).
6. Press back plate back into original position.
Inside Indicator
Outside Indicator
Note:
Verify handing on both outside and inside
indicators.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
LH LHRB
Left Hand
Reverse Bevel
Hinges Left
Open Outward
Spindle Cam Position
Door Hand:
RH/RHRB
Outside Indicator
Door Hand:
LH/LHRB
Inside Indicator
Figure 8
RH
Right Hand
Hinges Right
Open Inward
Figure 7
RHRB
Right Hand
Reverse Bevel
Hinges Right
Open Outward
Plate slot
for removal
Display Slide
Slot
Back
Plate
Spindle Cam
Figure 9
5
FM521 08/19