Installing the Network Module
IMPORTANT: The batteries must be removed prior to removing and/or inserting the
network module:
• Remove battery cover
• Remove batteries
• Remove and/or insert network module
• Reinstall batteries
Use Feature Programming step 7 (page 18) for enrollment of the Network Module.
Replace/Install Cylinder
1. Remove cylinder:
A. Repeat previous steps for removing the exterior lever handle.
B. Remove cylinder.
2. Install new cylinder:
A. Insert cylinder in exterior lever.
B. Insert key in cylinder; rotate the key 90° clockwise.
C. Push handle in allowing holes for set screw to align.
D. Insert set screw and tighten by turning set screw counter-clockwise.
E. Verify that new cylinder fits and rotates freely.
F. Test operation of the new cylinder/key.
An ASSA ABLOY Group brand
22
P/N AYRT-210-INST-FUL Rev E