Table of Contents
Advertisement
ED2400 & ED2400(A) Series Surface Vertical Rod
Exit Devices
Installation Instructions
4
Installation
a
Install Device
1. Mount trim (Follow instructions with trim).
2. Seat bar in place. Fasten device head (2 PRHMS or SNB). (Figure 10)
3. Set bar level. Locate end clamp holes.
4. Prepare end clamp mounting holes. Mount end clamp (2 #1/4-20 PRHMS or 3/8" (10 mm) dia.
SNB).
5. Check slide action (Slide travel = 9/16" (14 mm)).
• Depress touchbar (slide should move up). Release touchbar (slide should fall back to original
rest position).
• Activate trim (slide should move up). Release trim activator (slide should fall back to rest
position).
• NOT FOR FIRE DEVICES - Depress touchbar, turn dogging key clockwise (bar must remain
depressed, slide must remain in up position). Turn dogging key counterclockwise (bar should
extend, slide should fall back to rest position).
6. Tighten all mounting screws.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 10
10
FM572 10/22
Advertisement
Table of Contents
