Table of Contents
Advertisement
CL3300 Series
Cylindrical Lockset
Installation Instructions
3
Cylinder Installation (continued)
c
Interchangeable Core Removal
1. Insert key marked CONTROL and turn clockwise approximately
15˚. (Figure 10)
2. Pull core and tailpiece completely out of lever.
d
Install Standard Cylinder
1. Make sure lock is unlocked.
2. Make sure cylinder tailpiece is aligned
in same direction as cylinder bible.
3. Slide cylinder all the way into lever.
• For 6-pin cylinder: Fold retainer at
• For 7-pin cylinder: Break retainer at
Standard Cylinder Tailpieces
Note:
Dimensions are given in inches (")
and millimeters (mm).
e
Conversion Kit for Schlage
1. Remove threaded collar and Schlage
2. Install CL3300 tailpiece with threaded collar.
3. Adjust collar for proper end play of plug.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2012, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
hinge and press fit retainer halves
together as shown.
hinge and discard spacer section.
Also remove black cylinder spacer
from inside of chassis rollback
for clearance.
Cylinder
7/8"
7/8"
(22 mm)
(22 mm)
Cylinders with CL3300 Lockset
®
tailpiece.
®
Schlage
Tailpiece
Control Key
Core
Figure 10
Fold Retainer Halves
Lever
For 6-pin Cylinder
Remove Spacer
Retainer
and Discard
Cylinder
Bible
Cylinder
Tailpiece
For 7-pin Cylinder
ACTUAL SIZE SHOWN
Actual Size Shown
11/16"
6 PIN
6-pin
11/16"
(17 mm)
(17 mm)
Figure 11
®
Threaded
Collar
Figure 12
5
Hinge
Hinge
7 PIN
7-pin
Schlage
®
Cylinder
FM533 02/20
Advertisement
Table of Contents
