Table of Contents
Advertisement
®
R&S
NRQ6
5.1
RF Connector
See (1) in
Figure
The male N connector is used to connect the R&S NRQ6 to the device under test
(DUT) or a signal generator, see
on page 17.
For maximum measurement accuracy, tighten the RF connector using a torque
wrench with the recommended nominal torque. For details, see
DUT"
on page 17.
Risk of overloading the sensor
Using the R&S NRQ6 at a level above its upper measuring limit can dam-
age the sensor head. To avoid this risk, make sure not to exceed the test
limit.
5.2
Status Information
See (2) in
Figure
The status LED shows the state of the R&S NRQ6 by color and blinking fre-
quency.
Table 5-1: Possible states
Color
White
White
Yellow
Green
Turquoise blue Steady
Getting Started 1178.3705.02 ─ 07
5-1.
Chapter 4.4, "Connecting to a
5-1.
Illumination
Steady
Blinking
Steady
Steady
State
Idle
The sensor performs no measurement and is
ready for use.
Firmware update is in progress.
Waiting for trigger state.
Measurement is running.
Zeroing is in progress.
R&S NRQ6 Tour
Status Information
DUT",
"To connect to the
32
Advertisement
Table of Contents
