Table of Contents
Advertisement
®
R&S
NRQ6
c) R&S NRP‑Z5 using a R&S NRP‑ZK8 cable.
2. Connect the R&S NRP‑Z5 to the computer using a USB cable.
3. Connect the delivered external power supply unit to the R&S NRP‑Z5 and to
an AC supply connector.
4. If you want to use an external trigger source, connect the trigger input of the
R&S NRP‑Z5 to the trigger source using a BNC cable.
5. If you want to use the trigger signal externally, connect the trigger output of the
R&S NRP‑Z5 to the trigger device using a BNC cable.
4.6.3
R&S NRX Base Unit
You can use an R&S NRX base unit as controlling host. Connect the R&S NRQ6
to the R&S NRX using the host interface. The R&S NRX supports the configura-
tion of 2 directly connected R&S NRQ6, if enhanced accordingly. For details, see
the user manual and the data sheet of the R&S NRX.
The R&S NRX supplies an external reference signal that is provided by the LVDS
wire pair of the 8-pole sensor connector (M12).
Further information:
●
Chapter 6.3, "R&S
● R&S NRX user manual
Setup
NRQ6
Frequency Selective Power Sensor
Sample Clock I/O (Default: 120 MHz)
Figure 4-6: Setup with an R&S NRX base unit and one R&S NRQ6
1 = Signal source
2 = R&S NRQ6
3 = Host interface connector
4 = R&S NRP‑ZK8
5 = Sensor input connector of the R&S NRX
6 = R&S NRX base unit
Getting Started 1178.3705.02 ─ 07
NRX",
on page 47
LAN PoE+
Host
Interface
LO I/0
Preparing for Use
Connecting to a Controlling Host
28
Advertisement
Table of Contents
