Connecting To A Computer Or Base Unit; Computer - R&S NRT-Z14 Getting Started

®
R&S NRT-Z14/44
To disconnect from the DUT
1. CAUTION! Risk of electric shock and severe skin burns. See
directional power sensors"
Switch off the RF power before touching the RF connectors.
2. Unscrew the RF connectors by hand.
3.5

Connecting to a computer or base unit

For connecting the power sensor to a computer or base unit, use the host inter-
face. See Chapter 4.2, "Host
For operating the power sensor, you can choose from various possibilities. For
details, see Chapter 5, "Operating
3.5.1

Computer

As a controller, you can use a computer with a Microsoft Windows operating sys-
tem, equipped with R&S Virtual NRT or remote control software.
1
2 3
Figure 3-2: Connecting to computer
1 = R&S NRT‑Zxx directional power sensor
2 = host interface connector → sensor interface
3 = R&S NRT‑Z5 USB interface adapter
4 = USB connector → USB port
5 = computer
Getting Started 1443.8632.02 ─ 01
on page 6.
interface", on page 20.
concepts",
4
5
Connecting to a computer or base unit
on page 23.
Preparing for use
"Connecting
16