g
Make sure that the
127.0.0.1 (the factory-configured default).
Note
These network settings must match the UDP Data Export settings configured
in the M3 software. 127.0.0.1 is a loopback address (localhost). This address
assumes Hypack is running on the same computer as the M3 software.
h
Click
Network Test
Observe that the
i
Click
UDP Connect
Note
This network test will only work if data export has been enabled in the M3
software.
j
Click
Close
k
Select the
Offsets
922-00037041/1.1
value is set to 20002 and that the
Port
.
Network Connection
to confirm that data is being received from the M3 software.
to close the
Network Connection
tab.
Internet Address
dialog box opens.
dialog box.
Operating procedures
is set to
29