Kongsberg M3 Sonar Operator's Manual page 30

M3 Sonar PHS Operator Manual
e Enter the static draft distance you measured earlier into the
leave the vertical offset at zero if you are using RTK Tide.
Note
The MRU location (motion data output point) is pre-programmed into the Seapath
130 sensor unit at the factory. This location is based on using the centre of the
M3 Sonar transducer face as the reference point and on using a standard Pole
Mount height. If you have adjusted the height of the Pole Mount (or are using
your own Pole Mount for deployment) you will need to change these offsets in
the Seapath operator software.
5 Make sure that the M3 Sonar settings are correct.
a On the left side of the
Kongsberg Mesotech M3 entry under HYSWEEP Survey.
b Select the
Manufacturer / Model
c Click the
Setup
Observe that the
d Make sure that Use Raw Data is selected.
e Click to close the dialog box.
OK
f Select the
Connect
28
HYPACK Combined Hardware
tab.
button.
dialog box opens.
Simrad Setup
tab.
text box, or
Vertical
dialog box, click on the
922-00037041/1.1