Trouble Shooting; Repairs; Safety Procedures - probst VM-301-KJ-GREENLINE Operating Instructions Manual

Maintenance and care
7.3

Trouble shooting

DISTURBANCE
System does not start
System does not start (when lithium-
ion batteries are fully charged)
The system is running, but the machine
is not running.
The handbrake does not work
Machine does not start
Outrigger cannot be lifted
System is running, but machine is not
running
7.4

Repairs

Only persons with the appropriate knowledge and ability are allowed to repair the device.
Before the device is used again, it has to be checked by an expert.
7.5

Safety procedures

•
It is the contractor's responsibility to ensure that the device is checked by an expert in periods of
max. 1 year and all recognized errors are removed (→ see DGUV regulation 1-54 and DGUV norm 100-500).
•
The corresponding legal regulations and the regulations of the declaration of conformity must be
observed!
•
The expert inspection can also be done by the manufacturer Probst GmbH.
Contact us at: service@probst-handling.com
•
We recommend affixing the inspection sticker "„Sachkundigenprüfung / Expert inspection" in a clearly
visible place (order no.: 2904.0056+Tüv sticker with year number) after the inspection has been done.
51500024
CAUSE
Lithium-ion batteries are empty
12V battery is discharged
Seat switch is active
Brake pads worn out
Handbrake cable loose
Fuse blown
Battery defective
Hydraulic system has leakage
Too little hydraulic pressure
Handbrake is applied
V2
LIFTING
Charging Lithium-Ion Batteries
Charge 12V battery for operating
voltage
Press reset button (horn) 1 x
Replace brake pads
Adjust handbrake cable
Check fuses
Check battery
Repair leakage
Check oil level
Releasing the handbrake
42 / 43
GB