Safety Procedures; Equipment Attachments; Installation Machine; Safety In The Operation Of The Laying Machine - probst VM-301-KJ-GREENLINE Operating Instructions Manual

Safety
2.8

Safety procedures

2.8.1

Equipment attachments

During all adjustments on equipment attachments (e.g. HVZ-UNI) it must be ensured that the attachment
cannot close unintentionally. Risk of injury!
All adjustments may only be made when the laying machine is shut down (pull handbrake) and the engine is
switched off!
2.8.2

Installation machine

•
The installation machine has to be in good, safe working condition.
•
Never exceed the maximum capacity/working load limit (WLL) of the installation machine!
•
Only authorized and qualified persons are allowed to operate the installation machine.
•
The operator must have all the necessary qualifications.
2.8.3

Safety in the operation of the laying machine

•
The entry and exit may only be done from the left side (in the direction of travel) in order to avoid
unintentional activation of the controls.
•
The operation of the laying machine is generally only permitted under optimum visibility conditions and
enough lighting (e.g. daylight)!
•
By retrofitting appropriate headlamps (light package VM-301), work is also permitted in the dark.
•
Always lower the load to approx. 20 cm above the ground when moving!
•
The maximum load of the laying machine, its attachments (e.g. HVZ-UNI) and the loads attached to
them must not be exceeded!
•
When leaving the laying machine, the driver must pull the handbrake and ensure that the laying
machine is on a horizontal surface. If necessary, use wheel chocks or the like to prevent the laying
machine from rolling away unintentionally.
•
Unattended parking of the laying machine on inclined and sloping surfaces is not permitted!
•
During operation of the machine, the operator must always ensure that the machine is in a safe
operating condition.
•
Always disconnect the battery when working on the electrical system. Risk of electrical shock!
51500024 V2
11 / 43
GB