probst VM-301-KJ-GREENLINE Operating Instructions Manual page 40

Maintenance and care
Regular maintenance
In order to maintain the machine functions and to ensure a long operating life of the engine, the regular checks must be carried out according to the table
below.
Warranty claim for this device only exists if the prescribed maintenance work is carried out (by an authorised specialist workshop)! After
each maintenance interval has been carried out, this proof of maintenance (with signature and stamp) must be sent to us immediately (by
e-mail to service@probst-handling.de / by fax or post).
No. Maintenance work (① Order number see enclosed maintenance record
booklet)
4 Changing the hydraulic oil (RANDO HLP 46 ~ 25 l)
5 Check hydraulic oil level top up if necessary (RANDO HLP 46 ~ 25 l)
6 Replacing the hydraulic oil filter ①
17 Checking the electrical wiring for loose connections
19 Recharge the 12V battery ⑤
21 Replacement of windscreen wiper water including antifreeze
22 Check the antifreeze in the windscreen wiper water (before each frost period).
26 Check the hydraulic hoses for leaks (
tighten connections
).
27 Check the function of the instruments and controls.
28 Check the machine for damaged, deformed components and abnormal noises.
29 Tighten all screws and nuts, replace missing screw connections.
30 Checking the tyre pressure (front 2.5 bar/36 psi, rear 2.2 bar/32 psi)
31 Lubrication according to lubrication schedule
32 Check ball joint for strength (135 Nm)
33 Check load-bearing components for cracks (axles, chassis, swivel legs),
steering linkage)
34 Tighten all wheel nuts (130 Nm)
35 Check the handbrake (readjust 3-4 teeth if necessary)
36 Check the wheel bearing and adjust the axle pivot bearing if necessary.
37 Check steering play
Replace ball head or track rod if necessary ①
38 Checking the alternator
39 Adjusting the valve clearance of the toggle lever (0.15 mm)
During welding work, the plug connection to the batteries must generally be disconnected, as otherwise damage to the
electronics can occur!
Visual inspection before each start-up: Hydraulic oil
② and additionally every 50 hours / ③ replace every 400 hours / ④ replace every 500 hours
⑤ at the latest after approx. 40-50 days idle state of the machine
51500024
Before
each
commissi
oning
⚫
V2
After Ever Ever Every Every
first 50 y 100 y 1000 year
hrs. hour 200 hour
s hour s
s
⚫ ⚫
⚫ ⚫
⚫ ⚫ ⚫
⚫
②
⚫ ⚫ ⚫
⚫ ⚫ ⚫
⚫ ⚫ ⚫
⚫ ⚫ ⚫
⚫ ⚫ ⚫
⚫ ⚫ ⚫
⚫ ⚫
⚫ ⚫ ⚫
⚫ ⚫ ⚫
⚫
⚫
⚫
⚫
39 / 43
Every
2
years
⚫
⚫
⚫
⚫
⚫
⚫
GB