Operation
4.7.3
Electronic Joystick
• The electronic joystick (Fig. 1A) controls the operation of the
attachments). For example the opening and closing of the main
clamping ③ and secondary tension ④ of a hydraulic laying clamp HVZ
(→picture A).
As well as turning the hydraulic turning head (pressing the red knob on
the joystick - see Fig. 1A)
Vacuum operation:
•
Switch on vacuum →Press the blue button on the joystick (see Fig. 1A)
.
•
Lower the boom arm downwards (with lifting pedal (Fig. B)).
•
Place the vacuum suction plate on the load (stone plate).
•
Move the boom arm upwards with the left foot pedal
(Fig. B).
•
Move the load (stone slab) carefully to its destination.
•
Lower the load (stone slab) (with lifting pedal (Fig. B)).
•
Place the load on the floor and move the joystick forward (vacuum is
interrupted).
•
Immediately move the boom arm upwards again (Fig. B),
otherwise the joystick will be released (in the middle position) and the
boom operation will be active again immediately!
•
Switch off vacuum →Press the blue button on the joystick.
Closing the secondary tension
and
Counterclockwise turning
head
+
51500024
Closing the main
clamping
③
Opening the main clamping
V2
28 / 43
④
Fig. A
Fig. B
Opening the side clamping
and
Turning head clockwise
+
Picture 1A
GB