Table of Contents
Advertisement
Access 600 M802
FE6600/BL6600/MP6600 Series Multi-point Lock
Installation Instructions
7
Installation Instructions, continued
Confi gure the DIP Switch Settings
d
IMPORTANT: This product is built and factory tested to the configuration specified. Any change to the
3-position DIP-switch settings located at the bottom of the mortise lock body must be made prior to
lock installation.
Install Lock Body
e
NOTE: Do not pull the lock into the pocket using the harness alone.
Ensure that the wire harness is not pinched between the lock and the mortise pocket.
1. Feed the wire harness into the mortise pocket and
through inside preparation hole as shown below.
2. Carefully push the lock body into the pocket
while lightly applying tension to the wire harness.
3. Insert (2) #12-24 screws into the
lock body and tighten* with a
screw driver.
*Do not fully
tighten until levers
are installed and
properly aligned.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1 2 3
DIP Switch
Normally
(2) #12-24
screws
Handing
RH & RHR
LH & LHR
Check Polarity:
Verify + (red wire)
RX Output
Normally
Open
Closed
Ground
Wire
Wire
Harness
12
Actuator Operation
Fail Secure
Fail Safe
FM452 07/20
Advertisement
Table of Contents
