Advertisement
SN200/210 Integrated Wired
With and Without MELR Option (Electric Latch Retraction)
8B Position Inside Escutcheon & Wires (MELR)
1. Position escutcheon against door by
hooking the top edge on the top of the MELR
assembly. Verify that no wires are being pinched.
2. Mount inside escutcheon assembly to
plate using (1) #8-32 x 5/8" Phillips flat
head undercut machine screw (Figure 8b).
1. Concealed Door Position Switch Model 708F989 is included with this product.
System integrator shall determine use and installation location.
2. Drill a 1" Diameter Hole for both the Magnet and the Switch. Both holes shall
be 1" Deep and for the Switch (if needed) drill a 1/4" hole for the wires.
3. Connect the common wire of the switch to the common input terminal of
the EAC.
4. Connect the normally open wire of the switch to the normally open input
terminal of the EAC.
Machine
screw detail
7) Concealed Door Position Switch Instructions
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
18
reserved. Reproduction in whole or in part without the express written permission of
ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Fig. 8b (MELR)
Access
Control System
12VDC: Optional 24VDC
Lock Available
(Reader is always 12VDC)
Door
Position
Switch
McKinney
Electric
Hinge
Advertisement
