Prepare Lock Body (If Necessary) - Assa Abloy Corbin Russwin Access 600 TCRNE1 Series Installation Instructions Manual

Access 600 M802
FE6600/BL6600/MP6600 Series Multi-point Lock
Installation Instructions
7 Installation Instructions, continued

Prepare Lock Body (if necessary)

c
Reverse Lock Hand
Red surface of locking piece must face the outside/
locked side of door.
1. To rotate locking piece, position lock body
with red surface of locking piece visible. See
figure to the right.
2. Insert blade type screwdriver into locking
piece slot to rotate locking piece toward back
of lock body.
3. Rotate the locking piece 180° until RED
surface is on opposite side.
NOTE: Red indicates locked side (outside).
The beveled surface of the latch must face
the strike. See image to the right. The dead
latch is self adjusting.
To change hand of the latchbolt:
1. Insert screwdriver into the spade shaped
slot.
2. Rotate the screwdriver 90º to push the
latch out until the back of the latch clears
the lock front.
3. Rotate the latch 180º . The latch will then
re-enter the lock body.
NOTE: The latch cannot be unscrewed.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Locking Guide
Slot: Red color
indicates locked
side
11
FM452 07/20