Table of Contents
Advertisement
SE LP10
FE6600/BL6600/MP6600 Series Multi-point Lock
Installation Instructions
7
Installation Instructions, continued
Confi gure the DIP Switch Settings
d
IMPORTANT: This product is built and factory tested to the configuration specified. Any change to the
3-position DIP-switch settings located at the bottom of the mortise lock body must be made prior to
lock installation.
Install Lock Body
e
NOTE: Do not pull the lock into the pocket using the harness alone.
Ensure that the wire harness is not pinched between the lock and the mortise pocket.
1. Feed the wire harness into the mortise pocket and through inside preparation hole as shown below.
2. Carefully push the lock body into the pocket while lightly applying tension to the wire harness.
3. Insert (2) #12-24 screws into the lock body and tighten* with a screw driver.
*Do not fully tighten until cylinder
and levers are installed and properly
aligned.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
RH & RHR
1 2 3
DIP Switch
Normally
Open
Handing
LH & LHR
Check Polarity:
Verify + (red wire)
RX Output
Normally
Closed
Inside of Door
(2) #12-24 x 1/2"
Flat Head Philips
Screws (Metal
Doors)
(2)#12 x 1-1/4" Flat Head Wood
Screws (Wood Doors)
12
Actuator Operation
Fail Safe
Fail Secure
FM456 08/20
Advertisement
Table of Contents
