Connect Electrolynx; Position Outside Wires - Assa Abloy Corbin Russwin Access 600 TCRNE1 Series Installation Instructions Manual

Access 600 M802
FE6600/BL6600/MP6600 Series Multi-point Lock
Installation Instructions
7 Installation Instructions, continued

Connect ElectroLynx

j
1. Connect P3 (2-pin connector) from lock
body to J3 on interior PCB assembly.
2. Connect P4 (6-pin connector) from lock
body to J4 on interior PCB assembly.
3. Connect P5 (7-pin connector) from Reader
board to J5 on interior PCB assembly.
4. Connect ElectroLynx harness (4 and 8-pin)
from door harness to ElectroLynx harness on
interior PCB assembly.
NOTE: Connectors go on only one way. Do not
offset connector. They must be completely
seated.
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
1-Violet Lock
Neg
(Actuator, neg)
2-Gray Lock Pos
(Actuator, pos)

Position Outside Wires

k
To prevent any damage caused by pinching wires, follow these steps prior to installing inside escutcheon
assembly:
1. Insert the ElectroLynx connectors (8 and 4-pin) and establish their position inside the door prep
(Figure 5).
2. Neatly fold the wires onto themselves and into the remaining space to prevent pinching of wires
when mounting escutcheon (Figure 6). Do not tuck extra mortise lock body wires back inside the
lock body cylinder hole.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
J1
3-Pink 1- Black
DPS (NC) PWR NEG
4-Tan 2-Red
DPS (COM) PWR POS
Figure 5
From Reader
Board P5 to J5
To ElectroLynx
Harness
J2
From Lock
Body P4 to J4
From Lock
Body P3 to J3
3-White 5-Orange 7-Brown
DATA 1 RX (NO/ EGND
NC)
4-Green 6-Blue 8-Yellow
DATA 0 RX (COM) LED
16
J1
Figure 6
FM452 07/20