Prepare Lock Body (If Necessary) - Assa Abloy Corbin Russwin SE LP10 Series Installation Instructions Manual

SE LP10
FE6600/BL6600/MP6600 Series Multi-point Lock
Installation Instructions
7 Installation Instructions, continued

Prepare Lock Body (if necessary)

c
Reverse Lock Hand
Red surface of locking piece must face the outside/
locked side of door.
1. To rotate locking piece, position lock body
with red surface of locking piece visible. See
diagram to the right.
2. Insert blade type screwdriver into locking
piece slot to rotate locking piece toward back
of lock body.
3. Rotate the locking piece 180° until RED
surface is on opposite side.
NOTE: Red indicates locked side (outside).
Reverse Latch Hand
Beveled surface of latch must face strike. See
diagram at right.
The deadlatch is self adjusting.
To change hand of latchbolt:
1. Insert screwdriver into the spade
shaped slot.
2. Rotate screwdriver 90º to push latch out
until back of latch clears lock front; then
rotate latch 180º.
Latch will then re-enter lock body.
NOTE: Latch cannot be unscrewed.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Locking Guide
Slot: Red color
indicates locked
side
11
FM456 08/20