Installing The Sim Card - Teldat Connect-104V Manual

Teldat S.A.
Fig. 19: USB 3G Connector

3.7 Installing the SIM card

The Teldat Connect 104V router has a Wireless WAN interface that needs a SIM card to operate. Certain services
(CDMA) provided by several carriers in some countries do not require SIM cards.
To access the cellular module SIM tray, open the flap located on the underside of the router. This is shown in the fol-
lowing figure:
Fig. 20: WWAN cellular module SIM tray
Insert the SIM as follows: first, locate the slot and remove the flap. The SIM tray is now visible. Then carry out the fol-
lowing steps:
(1) Using a fingernail, pull the visible flap slightly back towards the OPEN arrow in order to release it from the
plastic lip holding it.
(2) Open the tray.
(3) Insert the SIM card inside the tray, paying particular attention to its edges. If it isn't correctly inserted, the tray
won't close.
(4) Return the tray holding the SIM card to its original position.
(5) Again, using a fingernail, pull the top flap slightly back (as in step 1) so it gently slides back under the plastic lip
without damaging the holder. The card is now securely held.
Teldat Router Connect-104V
3 Components and Power Supply
15