Jeep 2020 RENEGADE Owner's Manual page 64

62 GETTING TO KNOW YOUR VEHICLE
Operation Switch
1 — Front Panel Open/Close Switch
2 — Front Panel Vent Switch
To automatically retract the front panel to the
open position, push the open/close button and
release. From the fully open position, pull the
open/close switch and release. The front panel
will close completely.
To stop the movement of the front panel during
automatic closing or opening, briefly push the
open/close switch.
Venting The Front Panel
To vent the front panel push and release the
vent switch.
During the vent operation any push on the
open/close switch will stop the closing of the
panel.
NOTE:
If the My Sky is in open position, the vent

switch must be held until the panel vents.
The power roof controls will operate only

when the ignition is in the ON/RUN position.
If the Remote Start functionality is active, it

will not be possible to move the roof.
Auto-Reverse Feature
The front panel of the retractable roof is
equipped with an auto-reverse safety system
that is able to detect the presence of an
obstacle during the opening and closing motion
of the panel.
When this event occurs, the front panel stops
and reverses immediately.
NOTE:
With both panels removed the retractable roof
cannot be opened or closed.
Sunroof Reinitialization
The following procedure must be followed to
reinitialize the sunroof and calibrate obstacle
detection:
1. Place the ignition in the ON/RUN position.
2. Push and hold the front panel close switch
until the sunroof panel is fully closed, then
release the switch.
3. Open the driver side front door.
4. Place the ignition in the OFF position.
5. After 10 seconds, place the ignition back in
the ON/RUN position.
6. Push and hold the front panel close switch
again. The reinitialization process will begin
within 10 seconds. Do not release the
switch.
7. The sunroof will stop and an audible "click"
will be heard.
8. Release the front panel close switch, then
push and hold it again within 5 seconds. Do
not release the switch.