Table of Contents
Advertisement
CAUTION!
Do not attempt to raise the vehicle by jacking
on locations other than those indicated in the
Jacking Instructions for this vehicle.
1. Remove the spare tire, jack, and wheel bolt
wrench.
2. If equipped with wheels where the center
cap covers the wheel bolts, use the wheel
bolt wrench to pry the center cap off
carefully before raising the vehicle.
3. Before raising the vehicle, use the wheel
bolt wrench to loosen, but not remove, the
wheel bolts on the wheel with the flat tire.
Turn the wheel bolts counterclockwise one
turn while the wheel is still on the ground.
4. Place the jack underneath the jacking
location that is closest to the flat tire.
Jacking location is indicated by a stamped
arrow on the body. Turn the jack screw
clockwise to firmly engage the jack saddle
with the lift area of the sill flange, centering
the jack saddle inside the cutout in the sill
cladding.
Jacking Locations
Front Lifting Point
IN CASE OF EMERGENCY
265
Front Jacking Location
Rear Lifting Point
6
Advertisement
Table of Contents
