Table of Contents
Advertisement
300
SERVICING AND MAINTENANCE
problems, it may be a result of a leak in the
hydraulic clutch release system. See an autho-
rized dealer for service.
Use only manufacturer's recommended brake
fluid. Refer to "Fluids And Lubricants" in the
"Technical Specifications" section for further
information.
WARNING!
Use only manufacturer's recommended
brake fluid. Refer to "Fluids And Lubri-
cants" in the "Technical Specifications"
section for further information. Using the
wrong type of brake fluid can severely
damage your brake system and/or impair
its performance. The proper type of brake
fluid for your vehicle is also identified on the
original factory installed hydraulic master
cylinder reservoir.
WARNING! (Continued)
To avoid contamination from foreign matter
or moisture, use only new brake fluid or
fluid that has been in a tightly closed
container. Keep the master cylinder reser-
voir cap secured at all times. Brake fluid in
a open container absorbs moisture from
the air resulting in a lower boiling point. This
may cause it to boil unexpectedly during
hard or prolonged braking, resulting in
sudden brake failure. This could result in a
collision.
Overfilling the brake fluid reservoir can
result in spilling brake fluid on hot engine
parts, causing the brake fluid to catch fire.
Brake fluid can also damage painted and
vinyl surfaces, care should be taken to
avoid its contact with these surfaces.
(Continued)
Use of improper brake fluids will affect overall
clutch system performance. Improper brake
fluids may damage the clutch system result-
ing in loss of clutch function and the ability to
shift the transmission.
CAUTION!
Manual Transmission — If Equipped
Lubricant Selection
Use only the manufacturers recommended
transmission fluid. Refer to "Fluids And
Lubricants" in "Technical Specifications" for
further information.
Please see an authorized dealer for service.
Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 inch
(4.7 mm) below the bottom of the hole.
Add fluid, if necessary, to maintain the proper
level.
Please see an authorized dealer for service.
Frequency Of Fluid Change
Under normal operating conditions, the fluid
installed at the factory will give satisfactory
lubrication for the life of the vehicle. Fluid
changes are not necessary unless lubricant has
become contaminated with water.
NOTE:
If contaminated with water, the fluid should be
changed immediately.
Advertisement
Table of Contents
