Table of Contents
Advertisement
96
GETTING TO KNOW YOUR INSTRUMENT PANEL
Green Indicator Lights
Automatic High Beam Indicator Light — If
Equipped
This indicator shows that the
automatic high beam headlights are
on.
Cruise Control Set Indicator Light
This light will turn on when the speed
control is set to the desired speed.
Refer to "Speed Control" in "Starting
And Operating" for further
information.
Front Fog Indicator Light — If Equipped
This indicator light will illuminate
when the front fog lights are on. Refer
to "Exterior Lights" in "Getting To
Know Your Vehicle" for further
information.
Hazard Warning Lights
The hazard warning indicators light up
when the vehicles Hazard Warning
flasher switch has been pushed.
Park / Headlight On Indicator Light
This indicator light will illuminate
when the park lights or headlights are
turned on. Refer to "Exterior Lights" in
"Getting To Know Your Vehicle" for
further information.
Stop / Start Active Indicator Light — If
Equipped
This indicator light will illuminate
when the Stop/Start function is in
"Autostop" mode.
Turn Signal Indicator Lights
When the left or right turn signal is
activated, the turn signal indicator will
flash independently and the
corresponding exterior turn signal
lamps will flash. Turn signals can be activated
when the multifunction lever is moved down
(left) or up (right).
Gray Indicator Lights
Electronic Speed Control Ready/Canceled
Indicator Light
This indicator light will illuminate
when the speed control function is
ready (but not set), or canceled, by the
driver. Refer to "Speed Control — If
Equipped" in "Starting and Operating" for
further information.
ONBOARD DIAGNOSTIC SYSTEM (OBD II)
Your vehicle is equipped with a sophisticated
onboard diagnostic system called OBD II. This
system monitors the performance of the
emissions, engine, and automatic transmission
control systems. When these systems are
operating properly, your vehicle will provide
excellent performance and fuel economy, as
well as engine emissions well within current
government regulations.
If any of these systems require service, the OBD
II system will turn on the "Malfunction Indicator
Light (MIL)." It will also store diagnostic codes
and other information to assist your service
Advertisement
Table of Contents
