Table of Contents
Advertisement
294
SERVICING AND MAINTENANCE
Service Position Strategy
The service position allows the wiper blades to
be placed in a position that allows the wiper
blades to be easily changed.
To enable the Service Position Strategy, the
wipers must be in the Park position before
placing the ignition in the STOP/OFF position.
Service mode must be activated within two
minutes after the ignition is placed in the STOP/
OFF position.
To have a correct activation of strategy, the
Service Position command (antipanic) must be
active for at least half a second.
At every valid activation of Service Position
command, the wiper blades are activated for
250 ms.
The Service Position command can be repeated
several times to bring the blades into the
desired position, up to a maximum of three
times.
After three subsequent activations the strategy
is disabled.
Function Deactivation:
The functionality is reset if:
The ignition is turned to the MAR/RUN posi-
tion.
Number of subsequent activations is three.
Two minutes timer has expired after turning
the ignition OFF.
NOTE:
When turning the ignition ON, the blades will go
into the parking position.
Front Wiper Blade Removal/Installation
1. Lift the front wiper arm upward to raise the
wiper blade off of the windshield.
2. Push the release button on the arm of the
wiper blade.
3. Push the wiper blade up and remove it.
1 — Wiper Blade
2 — Release Button
3 — Wiper Arm
4. Install the wiper blade and firmly push the
wiper blade until it snaps into place.
Advertisement
Table of Contents
