Presta Valve; Schrader Valve; Brake System; Checking The Brake Linings For Wear - Kettler Scarpia FS 1.0 LTD Gold Translation Of The Original Operating Instructions

 Screw the valve cap tight.
 Screw the rim nut gently against the rim with
the tips of your fingers.

7.4.4.2 Presta valve


It is recommendable to use a
bicycle pump with a pressure
gauge. The operating
instructions for the bicycle pump
must be adhered to.
Unscrew and remove the
valve cap.
Open the knurled nut around
four turns.
Carefully apply the bicycle
pump so that the valve insert is
not bent.
 Pump up the tyre slowly and pay attention to
the tyre pressure in the process.
 The tyre pressure has been adjusted as per the
specifications.
 Remove the bicycle pump.
 Tighten the knurled nut with your fingers.
 Screw the valve cap tight.
Screw the rim nut gently against the rim with the
tips of your fingers.

7.4.4.3 Schrader valve


It is recommendable to use a
bicycle pump with a pressure
gauge. The operating
instructions for the bicycle pump
must be adhered to.
Unscrew and remove the
valve cap.
1
Connect the bicycle pump.
Pump up the tyre slowly and
pay attention to the tyre
pressure in the process.
 The tyre pressure has been adjusted as per the
specifications.
 Remove the bicycle pump.
 Screw the valve cap tight.
 Screw the rim nut gently against the rim with
the tips of your fingers.
MY20K03-2_1.0_18.07.2019
7.4.5

Brake system

CAUTION
!
Crash caused by brake failure
Worn brake discs and brake linings, as well as a
lack of hydraulic fluid in the brake cable, reduce
the braking power. This may cause a crash with
injuries.
 Check the brake disc, brake linings and the
hydraulic brake system on a regular basis and
replace if necessary.
The maintenance interval for the brake depends on
the weather conditions and how frequent the
pedelec is used. If the pedelec is used under
extreme conditions such as rain, dirt or high
mileage, maintenance must be performed more
frequently.
7.4.6

Checking the brake linings for wear

Check brake linings after brake has been fully
applied 1,000 times.
 Check that the brake linings are no less than
1.8 mm wide at any point and no less than
2.5 mm between the brake lining and
supporting plate.
 Push brake lever and hold. In doing so, check
the transport safety wear gauge can fit
between the brake lining supporting plates.
 The brake linings have not reached their wear
limit. If they have, a specialist dealer will need
to replace the brake linings.
7.4.7

Checking the pressure point

 Push brake lever and hold several times.
 If you are unable to clearly detect the pressure
point and it changes, a specialist dealer needs
to vent the brake.
7.4.8

Checking the brake discs for wear

 Check that the brake disc is no less than
1.8 mm at any point.
 The brake discs have not reached the wear
limit. If they have, a specialist dealer will need
to replace brake discs.
Cleaning and servicing
84