Charging The Battery - Kettler Scarpia FS 1.0 LTD Gold Translation Of The Original Operating Instructions

6.12.2 Charging the battery

WARNING
!
Fire and explosion due to defective batteries
The safety electronics on damaged or faulty
batteries may fail. The residual voltage can cause
a short circuit. Batteries may self-ignite and
explode.
 Never charge a faulty battery
CAUTION
!
Fire caused by overheated charger
The charger heats up when charging the battery.
In case of insufficient cooling, this can result in
fire or burns to the hands.
 Never use the charger on a highly flammable
surface (e.g. paper, carpet etc.).
 Never cover the charger during the charging
process.
 Never leave battery unattended during
charging.
Electric shock caused by penetration by
water
If water penetrates into the charger, there is a risk
of electric shock.
 Never charge the battery outdoors.
Electric shock in case of damage
Damaged chargers, cables and plug connectors
increase the risk of electric shock.
 Check the charger, cable and plug connector
before each use. Never use a damaged
charger.
Notice
 If an error occurs during the charging process,
a system message is displayed. Remove the
charger and battery from operation
immediately and follow the instructions.
MY20K03-2_1.0_18.07.2019

The ambient temperature during the charging
process must be within the range from 0 °C to
40 °C.

The battery can remain on the pedelec or can
be removed for charging.

Interrupting the charging process does not
damage the battery.

If pedelec features two batteries, charging for
both batteries is started via pannier rack
battery.
 Remove the rubber cover from the battery.
 Connect the mains plug of the charger to a
normal domestic, grounded socket.
Connection data
Notice
 Check that mains voltage is correct. The
power source voltage must match the voltage
indicated on the charger nameplate. Chargers
labelled 230 V may also be operated at 220 V.
 Connect the charging cable to the battery's
charging port.

The charging process starts automatically.
 The LED light on the charger will light up once
charging starts.
1
Figure 67: LED light on the charger
Operation
230 V, 50 Hz
62