Gear Shift; Using The Derailleur Gears; Using The Hub Gear - Kettler Scarpia FS 1.0 LTD Gold Translation Of The Original Operating Instructions

6.16

Gear shift

The selection of the appropriate gear is a
prerequisite for a physically comfortable ride and
making sure that the electric drive system
functions properly. The ideal pedalling frequency
is between 70 and 80 revolutions per minute.
 It is advisable to stop pedalling briefly when
changing gears. This makes it easier to switch
gears and reduces wear on the drivetrain.

6.16.1 Using the derailleur gears

Only applies to pedelecs with this equipment
The speed and range can be increased while
applying the same force if you select the right
gear. Use the derailleur gears.
I
1
2
Figure 79: Down shifter (1) and up shifter (2) on the left (I)
and right (II) gear shift
 Select the appropriate gear with the shifter.
 The gear shift switches the gear.
 The shifter returns to its original position.
 Clean the rear derailleur if the gear change
blocks.
MY20K03-2_1.0_18.07.2019

6.16.2 Using the hub gear

Only applies to pedelecs with this equipment
Crash caused by incorrect use
If the rider applies too much pressure on the
pedals during a gear change and activates the
shifter or changes several gears at a time, their
feet may slip from the pedals. As a result, the
pedelec may flip over or fall, which may cause
injury.
Switching down several gears to a low gear may
cause the twist grip outer sleeve to suddenly
come off. This will not have an adverse effect on
the twist grip's correct functioning since the outer
guide returns to its original position after the gear
II
change is complete.
1
 Apply little pressure on the pedals while changing
gears.
 Never change more than one gear at a time.
The interior hub is not completely waterproof. If
2
water gets into the hub, it may rust and the gear
switch function may no longer function as a result.
 Never use the pedelec in places where water
may get into the hub.
In rare cases, noises may be heard from the rear
derailleur in the hub interior after a gear change.
This is normal when gears are changed.
Do not detach the hub. If you need to detach it,
contact your dealer.
Operation
CAUTION
!
Notice
76