Use Eshift; Eshift With Shimano Di2 Automatic Hub Gears; Hub Gears; Eshift With Manual Shimano Di2 - Kettler Scarpia FS 1.0 LTD Gold Translation Of The Original Operating Instructions

.
3
4
Figure 80: Example; Shimano Nexus gear shift: Twist
grip (1) for the hub gear with its screen (3), the direction of
rotation to switch up a gear (2) and the direction of
rotation to switch down a gear (4)
 Turn the twist grip.
 The gear shift switches the gear.
 The number on the screen display shows the
changed gear.

6.16.3 Use eShift

eShift refers to the integration of electronic gear
shift systems into the pedelec system.
6.16.3.1 eShift with Shimano DI2 automatic

hub gears

Only applies to pedelecs with this equipment
You can operate the automatic Shimano DI2 hub
gears in manual mode or automatic mode. You
used the shifter to change gears in manual mode.
In automatic mode, the shift system changes gear
automatically depending on the speed, pedalling
power and pedalling frequency.
You will find how to switch from automatic to
manual mode, depending on the shifter used,
described in your operating instructions for your
gear shift.
If you use the shifter when in automatic mode, the
gear system will change to the next gear, but it will
remain in automatic mode.
Manual gear changes in automatic mode
influence shift behaviour in your gear system and
adjust gear changes to your riding performance
since it is a self-learning system.
MY20K03-2_1.0_18.07.2019
2
1
If the system is switched on for the first time when
a new, unused wheel is used, the system will learn
the gears first. To do so, the automatic system
changes to the highest/most difficult gear and
then switches through all gears during the first
ride. The new gear is shown briefly on the display
screen each time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is also possible to switch gears under load or on
hills.
If the pedelec is brought to a halt from a speed
greater than 10 km, the system can automatically
switch back to a pre-set S T A R T G E AR .
You can set the S T AR T G E A R in the system
settings.
6.16.3.2

eShift with manual Shimano DI2

hub gears
Only applies to pedelecs with this equipment
The new gear is shown briefly on the display
screen each time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is also possible to switch gears under load or on
hills.
If the pedelec is brought to a halt from a speed
greater than 10 km, the system can automatically
switch back to a pre-set S T A R T G E AR .
You can set the S T AR T G E A R in the system
settings.
6.16.3.3 eShift with Shimano DI2 automatic
hub gears
Only applies to pedelecs with this equipment
The new gear is shown briefly on the display
screen each time it is changed. Since the drive
unit detects the gear shift and consequently
reduces motor assistance briefly, it is also
possible to switch gears under load or on hills.
Operation
77