Installing The Wheel In The Fox Fork; Wheel With Quick Release (15 Mm) - Kettler Scarpia FS 1.0 LTD Gold Translation Of The Original Operating Instructions

 Push in the quick release until you hear a
clicking sound. Make sure that the flange is
extended.
Figure 36: Pushing the quick release in
 Adjust the clamping with a half-open clamping
lever until the flange reaches the fork end.
Figure 37: Adjusting the clamping
 Fully close the quick release. Check the quick
release to ensure it is firmly in place and adjust
on the flange if necessary.
 The lever is secured.
Figure 38: Closing the quick release
MY20K03-2_1.0_18.07.2019
5.3.4

Installing the wheel in the FOX fork

Only applies to pedelecs with this equipment

5.3.4.1 Wheel with quick release (15 mm)

The procedure for installing the 15 x 100 mm and
15 x 110 mm quick releases is the same.
 Place the front wheel in the fork ends of the
fork. Push the axle through the fork end on the
non-drive side and hub.
Figure 39: Pushing the quick release in
 Open the axle lever.
 Turn the axle five to six complete revolutions
clockwise into the axle nut.
 Close the quick release lever. The lever must
be tensioned to the point that it leaves a mark
on your hand.
 The lever must be 1 to 20 mm ahead of the fork
leg in the closed position.
1-20 mm
Figure 40: Spacing between lever and fork leg
 If the lever is tensioned too little or too much
when closed in the recommended position
(1 to 20 mm ahead of the fork), the quick
release must be adjusted.
Assembly
36