Eshift With Nuvinci H|Sync/Enviolo With Optimized H|Sync; Eshift With Rohloff E-14 Speedhub - Kettler Scarpia FS 1.0 LTD Gold Translation Of The Original Operating Instructions

6.16.3.4 eShift with NuVinci H|Sync/enviolo
with Optimized H|Sync
Only applies to pedelecs with this equipment
N U V I NC I C A D E N C E mode allows you to
reduce or increase the desired pedalling
frequency using the plus button or minus button
on the operating unit.
If you hold the plus button or minus button down,
you can increase or reduce the pedalling
frequency in increments of five. The desired
pedalling frequency is shown on the display
screen.
N U V I NC I G EA R mode allows you to switch
between several specified transmissions using
the plus button or minus button on the control
panel. The selected transmission (gear) is shown
on the display screen.
6.16.3.5

eShift with Rohloff E-14 Speedhub

500/14
Only applies to pedelecs with this equipment
The new gear is shown briefly on the display
screen each time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is also possible to switch gears under load or on
hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set S TA R T
G E A R .
You can set the S T AR T G E A R in the system
settings.
MY20K03-2_1.0_18.07.2019
Operation
78