Camera Connections - FLIR Quasar CP-6408-21-I Installation And User Manual

Installation
3.3

Camera Connections

CP-6408-21-I Connectors
Connector
1 N/A DC12V IN
2 2 LAN
3 3 AC24V IN
4 1 DEFAULT
14-pin terminal
5 4
block
6 N/A VIDEO
CP-6408 Range Installation and User Guide - Revision 120 - September 2020
Connection
If using a 12 VDC power supply, connect its wires to the
two-pin terminal block. See pin assignment below.
CP-6408-21-I: Do not use the DC12V IN and AC24V IN
connectors at the same time.
Attach a Cat 5e or Cat 6 cable from the network switch to
the RJ45 LAN connector for a 10/100/1000 Mbps Ethernet
and PoE connection. For information about using PoE, see
Supplying Power to the Camera. Verify that the LAN
connector LEDs are steady green and flashing yellow.
If using a 24 VAC power supply, connect its wires to the
three-pin power terminal block. See pin assignment below.
CP-6408-21-I: Do not use the DC12V IN and AC24V IN
connectors at the same time.
To reset factory defaults at any time, press the Default
button for at least 20 seconds.
Attach wires from external devices to the 14-pin terminal
block connector for alarm and audio in/out (see diagram and
definitions below).
BNC connector for analog video output.
This document does not contain any export-controlled inf ormation.
CP-6408-31-I Connectors
11