Unpacking; Connection And Running In; Setting Up The Remote Control - Canton Smart Sounddeck 100 Operating Instructions Manual

English

Unpacking

Unpack the box carefully and check that all the following parts
are present:
Delivery content
• 1x Smart Sounddeck 100
• 1x Remote control
• 1x Power cord
• 1x HDMI® cable
• 1x Optical digital audio cable
• 1x Coaxial digital audio cable
• 1x Analog stereo audio cable
• 1x Short manual
Connection
Place the Sounddeck 100 in the desired location and
connect it to the power input using the power cord. Make
sure that your TV is plugged in. If you want to connect the
Sounddeck 100 to the WiFi, please make sure your WiFi
router is active and has a connection to the Internet.
10
Running in
Running-in phase until the development of the
maximum sound properties: 15 – 20 operating hours.
• Please listen at normal volume during this time
• Avoid extremely high levels
• Listen to a variety of audio material
Setting up the
remote control
The remote control comes with a
battery already installed. Simply
remove the protective film to
activate. When replacing the
battery ensure that it is correctly
inserted according to the polarity
markings (+/–).
Only use the battery specified for
this system (CR 2032).
OPEN CLOSE
CR 2032