Unpacking And Connection; Running In; Setting Up The Remote Control - Canton Smart Soundbar 10 Operating Instructions Manual

English
Unpacking
Unpack the box carefully and check that all the following parts
are present:
Delivery content
• 1x Smart Soundbar 10
• 1x Remote control
• 1x Power cord
• 1x HDMI® cable
• 1x Optical digital audio cable
• 1x Coaxial digital audio cable
• 1x Analog stereo audio cable
• 1x Short manual
• 8x Rubber feet
Connection
Place the Soundbar 10 in the desired location and connect it
to the power input using the power cord. Make sure that your
TV is plugged in. If you want to connect the Soundbar 10 to
the WiFi, please make sure your WiFi router is active and has
access to the Internet.
74

Running in

Running-in phase until the development of the
maximum sound properties: 15 – 20 operating hours.
• Please listen at normal volume during this time
• Avoid extremely high levels
• Listen to a variety of audio material
Setting up the
remote control
The remote control comes with a
battery already installed. Simply
remove the protective film to
activate. When replacing the
battery ensure that it is correctly
inserted according to the polarity
markings (+/-).
Only use the battery specified for
this system (CR 2032).
OPEN CLOSE
CR 2032