Factory Reset [Res]; Network Setup [Nws]; Network Select [Nwc] - Canton Smart Sounddeck 100 Operating Instructions Manual

English

Factory Reset [RES]

With this function you can reset the Smart Sounddeck 100 to its factory settings. In case the Sounddeck 100 has a mailfunction or does not
connect to a network anymore, please perform such a reset and repeat the installation process before you contact the customer support.
Caution: ALL settings you have made, transmitted IR codes, the WiFi connection and paired (mobile) devices and speakers will be deleted!
To perform the reset please do as follows:
Power up your Sounddeck 100 by pressing the Power button " " on the remote.
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate to the menu System Setup [SYS] and confirm with the "OK" button.
3
Use the " " or " " button to select the function Factory Reset [RES] and confirm with the "OK" button. The OSD shows the menu Fac-
4
tory Reset and "No" is selected, the display shows [NO].
If you want to cancel the reset precedure, press "OK", or press the menu key "M".
5
If you want to perform the reset, select "Reset all" using
6
The OSD shows "Please Wait", the display still shows [YES]. After about 10 seconds the Sounddeck 100 turns off and starts up again.
7
During the starting process the LED flashes green rapidly.

3. Network Setup [NWS]

The third menu item of the Main Menu includes the Setup of the network connection. It contains the two items:

• Network Select [NWC]

• Network Reset [NWR]
Network Select [NWC]
At this menu the connection way of the WiFi module is set. The module can be connected Wireless [WLA] or Wired [ETH] using the Ethernet
port of the Smart Sounddeck 100.
To change the connection way from wireless to wired or contrary, do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu Network Setup [NWS] and confirm with the "OK" button.
2
36
" " or " " key and press "OK". The display shows [YES].