Canton Smart Sounddeck 100 Operating Instructions Manual page 52

English
Problem
A (slave)speaker
shows [WLS] in the
display.
The subwoofer does
not reproduce sound.
No connection can be
established between
the network router
and the Sounddeck
100.
Your WiFi network is
not displayed during
setup.
The Sounddeck 100
is not indicated in the
app on your (mobile)
device.
52
Possible cause
1. The slave speaker is operated without the
Sounddeck 100.
2. The (slave-) speaker is not paired anymore.
1. The Smart subwoofer is not paired, till now.
2 The subwoofer is connected to the Sounddeck
100 using a RCA cable, but Sub Out is set to Off
(not activated).
1. The DHCP server is deactivated in the router.
2. A filter for MAC addresses was created in the
network router.
3. Your router is not compatible with Chromecast
built-in.
1. The network connection for the Sounddeck
100 is set to Ethernet [ETH].
1. Your (mobile) device and the Sounddeck 100
must be conncted to the same network.
Solution
1. Turn on the Sounddeck 100.
2. Pair the (slave-) speaker with the Sounddeck 100 accor-
ding to chapter Wireless Pairing [WSP].
1. Pair the Smart subwoofer with the Sounddeck 100 accor-
ding to chapter Wireless Pairing [WSP].
2. Activate the output Sub Out at the Sub Out menu [SUB].
1. Activate the DHCP server of the network router according
to the router's instructions.
2. Deactivate the MAC Address Filter resp. add the adress of
the Sounddeck 100.
3. Routers that are demonstrably compatible can be found
in the web link in the chapter "Using Chromecast built-in for
audio". However, there are more compatible routers.
1. Change the setting to WiFi [WIF] in the menu Network
Select [NWC].
1. Connect your (mobile) device resp. the Sounddeck 100 to
the corresponding network (e.g. when using a guest net-
work).