Isp Parameters; Ethernet; Table 10 Manually Assign A Wep Key - ZyXEL Communications P-2302HW-P1 Series User Manual

P-2302HW/HWL-P1 Series User's Guide
The following table describes the labels in this screen.

Table 10 Manually Assign a WEP key

LABEL
Do you want to
enable OTIST
Setup Key
Back
Next
Exit

3.2.4 ISP Parameters

This screen depends on the Connection Type you select.

3.2.4.1 Ethernet

Note: You cannot use the
service. You must use the screens discussed in
instead.
58
DESCRIPTION
Select Yes and the ZyXEL Device will automatically start OTIST once you finish the
configuration wizard.
Select No if you do not want to use OTIST.
Note: You must Start OTIST in the ZyXEL Device and in the wireless
device(s) within three minutes of each other. You can start
OTIST in the wireless devices and the ZyXEL Device in any
order.
Type a key (password) 8 ASCII characters long.
Note: If you change the OTIST setup key in the ZyXEL Device, you
must change it on the wireless devices too.
Click Back to display the previous screen.
Click Next to proceed to the next screen.
Click Exit to close the wizard screen without saving.
Connection Wizard if you subscribe to a Roadrunner
Chapter 6 on page 105
Chapter 3 Wizard Setup