Snmp Traps; Configuring Snmp; Table 98 Snmp Traps - ZyXEL Communications P-2302HW-P1 Series User Manual

P-2302HW/HWL-P1 Series User's Guide

18.3.2 SNMP Traps

The ZyXEL Device will send traps to the SNMP manager when any one of the following
events occurs:

Table 98 SNMP Traps

TRAP # TRAP NAME
0 coldStart (defined in RFC-1215)
1 warmStart (defined in RFC-1215)
4 authenticationFailure (defined in
RFC-1215)
6 whyReboot (defined in ZYXEL-
MIB)
6a For intentional reboot:
6b For fatal error:

18.3.3 Configuring SNMP

To change your ZyXEL Device's SNMP settings, click Advanced > Remote MGMT >
SNMP. The screen appears as shown.
Use this screen to control SNMP access to your ZyXEL Device. To access this screen, click
Management > Remote MGMT > SNMP.
224
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent to the manager when receiving any
SNMP get or set requirements with the wrong
community (password).
A trap is sent with the reason of restart before
rebooting when the system is going to restart (warm
start).
A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
Chapter 18 Remote MGMT