ZyXEL Communications P-2302HW-P1 Series User Manual page 213

Table 91 Management > Bandwidth MGMT > Summary
LABEL
WAN
Active
Speed
Scheduler
Maximize
Bandwidth Usage
WLAN
Active
Speed
Scheduler
Maximize
Bandwidth Usage
Apply
Cancel
Chapter 17 Bandwidth MGMT
DESCRIPTION
Select this to enable bandwidth management on the WAN. Bandwidth
management applies to all traffic flowing out of the router through the WAN,
regardless of the traffic's source.
Enter the amount of bandwidth for this interface that you want to allocate using
bandwidth management.
The recommendation is to set this speed to match the interface's actual
transmission speed. For example, set the WAN interface speed to 1000 kbps if
your Internet connection has an upstream transmission speed of 1 Mbps.
You can set this number higher than the interface's actual transmission speed.
This will stop lower priority traffic from being sent if higher priority traffic uses all of
the actual bandwidth.
You can also set this number lower than the interface's actual transmission speed.
If you do not enable Max Bandwidth Usage, this will cause the ZyXEL Device to
not use some of the interface's available bandwidth.
This field is not affected by the
Select Priority-Based to give preference to bandwidth classes with higher
priorities. Select Fairness-Based to treat all bandwidth classes equally.
Select this if you want the ZyXEL Device to divide any unallocated and unused
bandwidth among bandwidth classes that require bandwidth. Clear this if you want
to reserve bandwidth for traffic that does not match a bandwidth class or if you
want to limit the speed of this interface.
Select this to enable bandwidth management on the WLAN. Bandwidth
management applies to all traffic flowing out of the router through the WLAN,
regardless of the traffic's source.
Enter the amount of bandwidth for this interface that you want to allocate using
bandwidth management.
The recommendation is to set this speed to match the interface's actual
transmission speed. For example, set the WLAN interface speed to 1000 kbps if
your Internet connection has an upstream transmission speed of 1 Mbps.
You can set this number higher than the interface's actual transmission speed.
This will stop lower priority traffic from being sent if higher priority traffic uses all of
the actual bandwidth.
You can also set this number lower than the interface's actual transmission speed.
If you do not enable Max Bandwidth Usage, this will cause the ZyXEL Device to
not use some of the interface's available bandwidth.
This field is not affected by the
Select Priority-Based to give preference to bandwidth classes with higher
priorities. Select Fairness-Based to treat all bandwidth classes equally.
Select this if you want the ZyXEL Device to divide any unallocated and unused
bandwidth among bandwidth classes that require bandwidth. Clear this if you want
to reserve bandwidth for traffic that does not match a bandwidth class or if you
want to limit the speed of this interface.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to set every field in this screen to its last-saved value.
P-2302HW/HWL-P1 Series User's Guide
Bandwidth Management Wizard.
Bandwidth Management Wizard.
213