Ftp Command Configuration Backup Example; Configuration Backup Using Gui-Based Ftp Clients; Backup Configuration Using Tftp; Figure 244 Ftp Session Example - ZyXEL Communications P-2602HWLNI User Manual

Chapter 29 Tools
computer and renames it "
information on filename conventions.
7 Enter "

29.7.2 FTP Command Configuration Backup Example

This figure gives an example of using FTP commands from the DOS command prompt to save
your device's configuration onto your computer.

Figure 244 FTP Session Example

331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit

29.7.3 Configuration Backup Using GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-based FTP
clients.

Table 179 General Commands for GUI-based FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory

29.7.4 Backup Configuration Using TFTP

The ZyXEL Device supports the up/downloading of the firmware and the configuration file
using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should work over
WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To backup the
configuration file, follow the procedure shown next.
414
config.rom
" to exit the ftp prompt.
quit
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the
server for anonymous access. Anonymous logins will work only if your
ISP or service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
". See earlier in this chapter for more
P-2602HWLNI User's Guide