Snmp Traps; Configuring Snmp; Figure 200 Remote Management: Snmp; Table 141 Snmp Traps - ZyXEL Communications P-2602HWLNI User Manual

23.7.2 SNMP Traps

The ZyXEL Device will send traps to the SNMP manager when any one of the following
events occurs:

Table 141 SNMP Traps

TRAP # TRAP NAME
0 coldStart (defined in RFC-1215)
1 warmStart (defined in RFC-1215)
4 authenticationFailure (defined in
RFC-1215)
6 whyReboot (defined in ZYXEL-
MIB)
6a For intentional reboot:
6b For fatal error:

23.7.3 Configuring SNMP

To change your ZyXEL Device's SNMP settings, click Advanced > Remote MGMT >
SNMP. The screen appears as shown.

Figure 200 Remote Management: SNMP

P-2602HWLNI User's Guide
Chapter 23 Remote Management Configuration
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent to the manager when receiving any
SNMP get or set requirements with the wrong
community (password).
A trap is sent with the reason of restart before
rebooting when the system is going to restart (warm
start).
A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
351