Sip Qos Screen - ZyXEL Communications P-2602HWLNI User Manual

Chapter 11 Voice
Table 62 VoIP > SIP Settings > Advanced
LABEL
Enable
Server Address
Server Port
MWI (Message
Waiting
Indication)
Enable
Expiration Time
Call Forward
Call Forward
Table
Caller Ringing
Enable
Caller Ringing
Tone
On Hold
Enable
On Hold Tone
Back
Apply
Cancel

11.6 SIP QoS Screen

Use this screen to maintain ToS and VLAN settings for the ZyXEL Device. To access this
screen, click VoIP > SIP > QoS.
182
DESCRIPTION
Select this if your VoIP service provider has a SIP outbound server to handle voice
calls. This allows the ZyXEL Device to work with any type of NAT router and
eliminates the need for STUN or a SIP ALG. Turn off any SIP ALG on a NAT router
in front of the ZyXEL Device to keep it from retranslating the IP address (since this
is already handled by the outbound proxy server).
Enter the IP address or domain name of the SIP outbound proxy server.
Enter the SIP outbound proxy server's listening port, if your VoIP service provider
gave you one. Otherwise, keep the default value.
Select this if you want to hear a waiting (beeping) dial tone on your phone when
you have at least one voice message. Your VoIP service provider must support
this feature.
Keep the default value for this field, unless your VoIP service provider tells you to
change it. Enter the number of seconds the SIP server should provide the
message waiting service each time the ZyXEL Device subscribes to the service.
Before this time passes, the ZyXEL Device automatically subscribes again.
Select which call forwarding table you want the ZyXEL Device to use for incoming
calls. You set up these tables in VoIP > Phone Book > Incoming Call Policy.
Select the check box if you want to specify what tone people hear when they call
you. The ZyXEL Device provides a default tone, but you can add additional tones
using IVR. See Section 11.2.10 on page 176
Select the tone you want people to hear when they call you. You should set up
these tones using IVR first. See
Select the check box if you want to specify what tone people hear when you put
them on hold. The ZyXEL Device provides a default tone, but you can add
additional tones using IVR. See
Select the tone you want people to hear when you put them on hold. You should
setup these tones using IVR first. See
information.
Click this to return to the SIP Settings screen without saving your changes.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to set every field in this screen to its last-saved value.
for more information.
Section 11.2.10 on page 176
Section 11.2.10 on page 176
Section 11.2.10 on page 176
P-2602HWLNI User's Guide
for more information.
for more information.
for more