More Connections Edit Advanced; Figure 54 More Connections Edit Advanced; Table 27 More Connections Edit Advanced - ZyXEL Communications P-2602HWLNI User Manual

7.8 More Connections Edit Advanced

Click the Advanced button in the More Connections Edit screen to display the following
screen.

Figure 54 More Connections Edit Advanced

The following table describes the labels in this screen.

Table 27 More Connections Edit Advanced

LABEL
RIP & Multicast
Setup
RIP Direction
RIP Version
Multicast
ATM QoS
ATM QoS Type
Peak Cell Rate
Sustain Cell Rate
Maximum Burst Size Maximum Burst Size (MBS) refers to the maximum number of cells that can be
Back
Apply
Cancel
P-2602HWLNI User's Guide
DESCRIPTION
Select the RIP direction from None, Both, In Only and Out Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Management Protocol) is a network-layer protocol used to
establish membership in a multicast group. The ZyXEL Device supports both
IGMP version 1 (IGMP-v1) and IGMP-v2. Select None to disable it.
Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth for
voice or data traffic. Select UBR (Unspecified Bit Rate) for applications that are
non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty
traffic and bandwidth sharing with other applications.
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak
Cell Rate (PCR). This is the maximum rate at which the sender can send cells.
Type the PCR here.
The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted. Type the SCR, which must be less than the PCR. Note that system
default is 0 cells/sec.
sent at the peak rate. Type the MBS, which is less than 65535.
Click Back to return to the previous screen.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Chapter 7 WAN Setup
113