Upper Control Panel - Sony DVW-522 Operation Manual

2-1 Control Panel

2-1-1 Upper Control Panel

1 PHONES jack
Connect 8 stereo headphones to monitor the audio
during playback.
Adjust the volume level with the PHONES level
control.
2 POWER switch
Set to ON to turn the VTR on. The audio level meters
and time counter display light.
3 PHONES level control
Controls the level of the audio output from the
PHONES jack. You can enable this control to
simultaneously adjust the output level of the
MONITOR OUTPUT connector on the connector
panel.
For details, refer to the Maintenance Manual Part 1.
4 Indicators
Light or flash to show the status of the VTR.
2-2
Chapter 2 Locations and Functions of Parts and Controls
1 PHONES jack
2 POWER switch
3 PHONES level control
4 Indicators
Upper control panel
5 MONITOR SELECT buttons
VTR status indicators
Indicator
CHANNEL Indicate the condition of the playback signal.
CONDITION Green indicator: indicates that the condition
of the playback signal is good.
Yellow indicator: indicates that the playback
signal is somewhat deteriorated but is still
reproducable.
Red indicator: indicates that the playback
signal is too poor for reproduction.
MENU 1/2/3 Indicate the menu bank selected by the SET
UP SELECT switch on the system set-up
panel.
LTC Lights when the VTR is reading LTC
signals on the playback tape.
VITC Lights when the VTR is reading VITC
signals on the playback tape.
5 MONITOR SELECT buttons
Press to select the signals output from the MONITOR
OUTPUT L and R connectors.
You can mix the signals to be monitored by pressing
two or more channel buttons (CH-1 to 4) for the same
output channel (L or R).
Mixed signals from both the L and R output channels
are output from the RF ADAPTOR connectors.
VTR status