Table of Contents
Advertisement
2-3 Connector Panel
2-1 Control Panel
5 CONTROL PANEL connector (D-sub15-pin)
Connects the control panel through the 15-pin cable
supplied in the optional BKDW-510 Control Panel
Extension Kit to allow the control panel to be used in a
remote control configuration.
6 MONITOR OUTPUT connectors (XLR-3-32)
Output signals to the audio monitor in two signal lines:
L and R. The signals to be output are selected with the
MONITOR SELECT buttons on the upper control
panel.
By selecting the output signals, you can adjust the
volume level with the PHONES level control on the
upper control panel.
For details, refer to the Maintenance Manual Part 1.
Notes
• If you connect a transformer-less CANNON to PIN
converter to the MONITOR OUTPUT connectors to
obtain unbalanced output, it is recommended that you
change the level of the output signals from +4 dB
(standard) to 0 dB beforehand. If the level of the
output signal is kept at +4 dB, distortion may occur
when the output level is close to full scale.
For details on changing the output signal level, refer to the
Maintenance Manual Part 1.
• If you use the converter mentioned above and an
RFU adaptor kit at the same time, audio signal-
induced beat interference may occur in the video
signals output from the RFU adaptor kit.
If you wish to use the converter and the adaptor at the
same time, consult with Sony service personnel.
7 RS232C connector (D-sub 25-pin)
Accepts or sends RS-232C remote control signals and/
or VTR status data from/to external equipment.
2-10
Chapter 2 Locations and Functions of Parts and Controls
Advertisement
Table of Contents
