OPERATOR'S MANUAL
ROTARY RAKE
5.9. Clogging of the rake
In order to avoid clogging, mowing speed should be adjusted to the mentioned conditions. In
order to remove the machine clogging, lower the cutterbar onto the ground, disconnect the drive, take
ignition key off and pay particular attention. When eliminating the machine clogging, use also safety
means for operator, so protective gloves and tight wear.
5.10. Unmounting machine from tractor
CAUTION:
When dismounting, make sure there is no person in between the rake and the
tractor.
To dismount the rake from the tractor:
Set the machine onto an even, stable ground,
❑
Turn the tractor's ignition off and take the key out,
❑
Secure the machine against moving by placing wedges at wheels,
❑
Support the machine with the support legs and protect with safety pin,
❑
Dismount the PTO shaft and place it on a PTO shaft holder, which is standard-delivered with the
❑
machine, PTO shaft and power input ends should be protected with guards,
Detach the machine from the tractor,
❑
Carefully drive the tractor away.
❑
6. MOUNTING AND ADJUSTMENT
6.1. Tine mounting
Tines should be mounted as provided on scheme on Fig. 27.
Driving direction
WARNING:
Use only the tines recommended by the manufacturer.
Check condition of tines before each operation. Worn or damaged tines should
be replaced immediately.
Z-300 – Z-470
Fig. 27. Mounting of rake's tines
Gear's rotation direction
27